nea4wd.org

How about fixin the damn board width so we don't have to side scroll??

Try increasing your screen resolution to 1024x768. You may be set at 800x600.
The board width minimum is ~ 840px.
I have 5 pc's including 2 laptops and I do not have to scroll right on any of them. All of wich are set at 1024x768. So the only thing I can think of is your screen resolution.

For s&g's I decreased the NEA header giff to 700 (looked like crap but wanted to test) and the board still wanted to stay at 840.

Rich

I tried tha tRich but now the print is so small I can barely read it

What scottay said.

I addressed this earlier Paul but I think it is the Banner that throwing things off......

I reduced the banner to 700 again, and made a few other small changes.
The width should be ok for those using 800x600 resolution now.

Be sure to refresh your screen so the banner is replaced with the new.

Let me know if it's ok.


Rich

nhbasser wrote:I reduced the banner to 700 again, and made a few other small changes.
The width should be ok for those using 800x600 resolution now.

Be sure to refresh your screen so the banner is replaced with the new.

Let me know if it's ok.


Rich

It's fine for me now Rich. I still have a bit of a scroll bar but no scrolling necessary at 800x600 and my extremely puny monitor.

Thank you.

Shane

Shane wrote:
It's fine for me now Rich. I still have a bit of a scroll bar but no scrolling necessary at 800x600 and my extremely puny monitor.

Thank you.

Shane

That's cool.... Should I go a bit smaller?

Not for me Rich. I'm good. Thank you.

No this is PERFECT Rich, thanks